UtterPower.com

  

 

CS Lister Type Parts

Page under development

There are no 'fast moving' Lister Type parts.

but the following might be spares to consider.

Erica has parts on the shelf ready to ship. Expect to add shipping and handling .These parts are in the USA. We buy the best parts we can source, and we have no loyalty to a specific supplier.

Popular Super Quality Serpentine Drive Pulleys

DI heads (While they last!)

Glow plug for the CS engine  

Tappet Sets for CS Standards

New Governor Kit  Add this kit after you try the stock setup!                         

Lister type Banjo is key to fitting WESTERN made fuel filters and more.

Fuel Filter Adapter for Standard 4 bolt mounting on side of water jacket (like RA Listers).

Lifting Bar for the Standard Lister 6/1, and variants using the standard stud spacing. 

New Bronze Idler Gear  

Head gaskets

(Headgasket6/1CS)  Standard 6/1 $13.95each

(HeadGasket25/2) 127mm Bore $24.00each

 

 (BB+RK)  Bush Bear plus Ring Kit, for Lister 6/1 (Standard), also used in 8/1s. We have these in quantity, so you can have the wear parts on hand.

One set of quality Goetze rings 4+1 114.3mm (4 1/2 inches)
one new standard sized big end rod bushing
one small end rod bushing
one Piston Pin
one governor side cam bushing
one left side cam bushing

$69.95 plus shipping and handling
 


(BBK) Bush Bear Kit without rings

one new standard sized big end rod bushing
one small end rod bushing
one Piston Pin
one governor side cam bushing
one left side cam bushing

$59.95 plus shipping and handling

Rings

(R114.3mm)  4+1, 114.3 mm (Standards, used in most 6/1s, 12/2s, 16/2s   $19.95

(R120mm) 4+1, 120mm, used in many of the 10/1s and some of the 20/2s  $29.95

(R127mm) 4+1, 127mm, used in the 25/2 PS and Ashwamegh Twins  $29.95

Crankshafts

(Crank6/1TRB) 6/1 standard for TRBs, fitted with timing gear, crank pins polished at the factory  $169.95

Cam Shafts complete with governor

(Cam6/1)  6/1 Standard complete  $79.95

Exhaust Flange

(ExhflangeLT) For all Lister Types I've seen, including most Indian variants, this unit is often used with NPT pipe and fittings, threads are VERY close, and NPT tapp can be used to chase the threads if required. Construct custom intake systems with this part, this is a great piece to have for a spare and I have seen many in use on the intake side, as the bolt and port match is exact in all engines I've seen so far.  $12.95

Fuel filters  

(fuelfilter2bolt) Complete unit with Bosch (MICO) replaceable paper filter $19.95  (this is a good filter, not the Mickey Mouse crap found in all too many brands of Indian engines.

Replacement element $8 (I will post NAPA or other part number that will interchange as soon as I hear of a local replacement, this is a pretty common looking filter, I'll bet there's an interchangeable part!

Fuel Filter adapter, adapt North American Style 3 bolt spin on mounts to the standard 4 bolt Lister CS cylinders, these are heavy steel water cut plates 1/8 inch thick!  $19.95 each. (yes it was a mistake to make this mount so thick, overkill times 5).